Hey! You're probably on this page because you made the great decision to purchase a Flowermate Cap PRO.

We wanted to ensure that you have the best possible experience so we created this brief guide on how to to get the most out of your Flowermate Cap PRO.

 

You will have the following pieces included in the box:

  • Flowermate Cap PRO Vaporizer
  • USB Charging Cable
  • 1 x Cleaning Brush
  • 1 x Packing Tool
  • 1 x Chamber Screen
  • 1 x Mouthpiece Screen
  • User Manual

 

Charging your Flowermate Cap PRO

 

The Cap PRO should be charged using a USB cable (included with the device). You can find the charging port located at the bottom of the device.

The 2000mAh strong battery allows for 4-6 vaping sessions before it needs to be charged again. 

Charging time : 90 minutes

 

Perform a quick burnoff of the Flowermate Cap PRO's oven

 

Once the battery is fully charged, it is worth performing a ‘burn-off’ of the Cap PRO oven. This will clean the oven of any leftover residue from the manufacturing process.

To carry this out, activate the Cap pro by pressing the ‘up’ button 5 times in quick succession. Set it to it's highest temperature (230C). Heating will begin instantly, it will take around 20 seconds to fully heat.

Once the temperature has been reached, leave the device idle for 5 minutes and it should automatically switch off. Repeat once or twice as necessary.

Now the burn off is complete, the fun can start!

  

Packing your Flowermate Cap PRO

Ensure your herbs are finely ground (using a high quality grinder) before placing into the oven. Only fill your Cap PRO oven with herbs when it is switched off and cooled down.

Remove the magnetic mouthpiece to expose the oven, and fill it until it's at least ¾ full.. Carefully remove any excess plant material near the filling chamber so that the mouthpiece can be re-fitted tightly.

 

Setting the temperature

When the Cap PRO is switched on, you change the temperature in 1°C increments by pressing the ‘up’ or ‘down’ button on the side of the device once.

The temperature range is from 148°C - 230°C. Once you've set the temperature, the device will take 20 seconds to heat up before it's ready to use. 

To change the device from Fahrenheit to Celsius press the ‘up’ and ‘down’
button at the same time.

 

Cleaning your Flowermate Cap PRO

Clean your Cap PRO when it has cooled down completely. We recommended cleaning it after every 3-5 sessions to keep it in tip top condition.
To clean, remove the mouthpiece and empty the chamber. Clean the chamber with a cotton bud dipped in Vape Cleaning Solution.

Soak the mouthpiece in Vape Cleaning Solution for a couple minutes and finish with a rinse of warm water.

 

Further Reading

 

We are sure you'll enjoy your Flowermate Cap PRO!

If you have any questions, please contact us.

Happy vaping!

elevate